Assembly of the Legs - Top Section Start with 1/2 inch ACX plywood. Using Dave Painters drawings, I cut five wood section. Corners rounded with a 4" radius After the section were cut, I started wrapping each leg section with the pipe insulation. I used the smooth insulation with the adhesive. The adhesive helped keep the insulation in place while I stapled the insulation to the plywood After all section were wrapped, I cut out notched pieces of wood and places them inside the wood sections. This helped "squish" the height of the section to 8 inches. The wood dividers are just temporary as I'll have to change them when I build the next section of the legs. I still have to decide on a finish. I will either use liquid latex or Plastic Dip Spray. Parts list: 1/2 inch ACX plywood 3/4 inch clear pine for inside dividers Armstrong Pipe insulation. Fits 1/2 inch pipe and is 1 5/8 inch thick. Smooth finish. Part number 05812 97289. Purchased at Home Depot Cost so far: $60.00 Click to enlarge 1/2 Inch ACX Plywood Start wrapping insulation Closeup of Insulation Completed leg section Stacked leg section Stacked leg section Stacked leg section